Ultrasound system gets image quality makeover

UK scientists have successfully completed an initial trial of a new, potentially more reliable, technique for screening breast cancer using ultrasound.

UK scientists have successfully completed an initial trial of a new, potentially more reliable technique for screening breast cancer using ultrasound.

The team at the National Physical Laboratory (NPL; Teddington, UK) working with the University Hospitals Bristol NHS Foundation Trust are now looking to develop the technique into a clinical device.

Annually, 46,000 women are diagnosed with breast cancer in the UK, using state-of-the-art breast screening methods based on x-ray mammography. Only about 30 percent of suspicious lesions turn out to be malignant. Each lesion must be confirmed by invasive biopsies, estimated to cost the UK heath service £35 million per year. Ionizing radiation also has the potential to cause cancer, which limits the use of x-rays to single screenings of at risk groups, such as women over 50.

Hence there is a compelling need to develop improved, ideally non-ionizing, methods of detecting breast lesions and solid masses. Improved diagnosis would reduce unnecessary biopsies and consequent patient trauma from being wrongly diagnosed.

Ultrasound ticks many of the boxes: it is safe, low cost, and already extensively used in applications such as fetal scanning. However, the quality of the images is not yet good enough for reliable diagnoses.

Part of the problem lies with the current detectors used. Different biological tissues have different sound speeds, and this affects the time taken for sound waves to arrive at the detector. This can distort the arriving waves, in extreme cases causing them to cancel each other out. This results in imaging errors, such as suggesting abnormal inclusions where there may be none.

The new method works by detecting the intensity of ultrasonic waves. Intensity is converted to heat that is then sensed by a thin membrane of pyroelectric film, which generates a voltage output dependant on the temperature rise. As such, the researchers believe that imaging detectors based on this new principle should be much less susceptible to the effects caused by the uneven sound speed in tissues.

This technique, when used in a Computed Tomography (CT) configuration, should produce more accurate images of tissue properties and so provide better identification of breast tissue abnormalities. The aim of tomography is to produce a cross-section map of the tissue, which describes how the acoustic properties vary across the tissue. Using this map, it is possible to identify abnormal inclusions.

Having received positive results and proven the potential of the project, NPL is now seeking funding to develop the work further. Engineers on the project hope to produce a demonstrator using a full array of 20 sensors, which should allow more rapid scanning and move the idea towards a system which might eventually be used clinically. It is hoped that this will provide both a suitable resolution and fast enough scanning to become a viable replacement for current clinical scanners.

Following successful completion of the demonstrator, NPL and partners will look to work with a manufacturer to commercialize the technology.

-- Dave Wilson, Senior Editor, Vision Systems Design

More in Life Sciences